405-00026-00iNspect Express User’s Manual
112 Rev 1600; 12 July 2010
6. Hover over the third click point (second line), and extend the size of the search area to com-
pensate for movement of the part. Repeat for the second click point on this line.
Increasing the Search Area
7. Click on the Locator button. In the Configuration and Status panel, click on Position An-
chor.
8. In the image area, click on the intersection of the two pencil lines.
Position Anchor
Position Anchor at Pencil Line Intersection
NOTE The Position anchor alone can track or follow horizontal and vertical move-
ment, but not rotation. If your part is mechanically restricted to not rotate, for
example a square or rectangle part sliding between two closely fitting rails, the
Position anchor alone may be enough. If the part does rotate, you need a rota-
tion anchor too.
Commentaires sur ces manuels